SOFTWARE RELEASE NOTES
					======================

Application:		AXIS License Plate Verifier

Release date:		2019-10-28

Release type:		Production	      

Software version:	1.5.2	  

File name:		Licenseplateverfier_1_5_2.eap			         

Preceding Release:		 
-------------------------------------------------------------------------------

Contact Information
===================

Please contact Axis Communications for product information, updates and support
at http://www.axis.com.

-------------------------------------------------------------------------------

Compatible products
===================
See complete list of compatible products at www.axis.com.
* From verison 1.4.0 AXIS License Plate Verifier will no longer support camera models P1435-LE, Q1765-LE and P3225-LE.  For these camera models you should use version 1.2.0 or eriler verisons.

New Features in 1.5.2 since 1.5.0
===================================
* Minimum plate Width Symbols in Advanced mode.  This is for those plates that do not adhere to standard plates requirement, where by lowering the characters of the plate from 5 to 3, all the license plate that are under 5 characters will be recognized.

Corrections in 1.2.2 since 1.5.0
==================================
C01: Fixed an issue with "Vehicle Direction" when transmitting license plates to a controller (A1001).  The logic has been simplified, only direction settings will be considered as a condition for plates to be send to a controller when "Vehicle Direction IN or OUT" has been set.

Upload instructions
===================

In the supported product's web interface, go to the Applications menu and upload this application package. 
Start and configure the application.
For more instructions see the User Manual at www.axis.com.

Dependencies
============
To install and configure AXIS License Plate Verifier, you must use a supported browser.

Known Bugs/Limitations
================================
K01: If you move the region of interest more than 60º or if you place it outside the live view, it will automatically jump back to default position. Make sure the region of interest stays in position after you have saved the settings.

Supported Firmware
======================
9.10.1 or earlier versions.