PTZ DRIVER RELEASE NOTES
                 ========================

Release date: 2008-07-04

Release type: Production

Driver version: 2.07

Filename: VCC-2.07.ptz

Previous release: 2.06

---------------------------------------------------------------------

Release 2.07
=============

2.07:1 Fixed a problem when changing from auto-iris to manual iris on the
       NU-700 PTZ model.

Known problems and limitations in version 2.07
==============================================

Note! Some limitations are also model dependent and can behave
      different on different models!

2.07:2 To use this version of the driver, firmware 4.30 or higher
       is required.

2.07:3 If a unit in the daisy-chain is disconnected or have a power fail,
       communication with the following units are interrupted. See the
       help-page for more information.

2.07:4 A focus movement will stop any ongoing continuous zoom movements.

2.07:5 A focus movement will wait until an ongoing zoom movements is ready.


Known problems and limitations with NU-700 models.
======================================================
2.07:6  For manual iris control, the parameters "NU700 shutter speed" and "NU700 gain"
        (in "PTZ Configuration") will be used (default values for both = 1).

2.07:7  If changing the "NU700 shutter speed" or "NU700 gain" parameters, presets
        with manual iris (autoiris = off) might need to be adjusted.

2.07:8  Small manual iris values might behave unexpected.

2.07:9  It is not possible to mix NU-700 and other vcc models
	on the same server.

2.07:10  It is only possible to connect a single NU-700 unit

2.07:11  NU-700 only supports relative focus.

======================================================