PTZ DRIVER RELEASE NOTES
                 ========================

Release date: 2008-09-17

Release type: Production

Firmware version: 2.05

Filename: Sensormatic-2.05.ptz

Previous release: 2.04

---------------------------------------------------------------------

Release 2.05:
=============

2.05:1 Fixed a problem when going to a preset position. Sometimes, the signal
       that the movements were completed was never sent back from the
       PTZ-driver. This problem could influence Guardtour, Events and
       Motion detection applications.


Known problems and limitations in version 2.05
==============================================

Note! Some limitations are also device type dependent and can behave
      different on different Sensormatic devices!

2.05:2 To use this version of the driver, firmware 4.30 or higher
       is required.

2.05:3 A manual focus movement may disable auto-focus
       (Sensormatic device type dependent).

2.05:4 A manual iris movement may disable auto-iris
       (Sensormatic device type dependent).

2.05:5 The auto-focus or auto-iris command will set both
       auto-focus and auto-iris at the same time. It is not possible
       to set only one of them.

2.05:6 Some Sensormatic device types may only have a fixed focus setting
       (no focus adjustments possible).

2.05:7 After start, it may take some time before the RS485 serial
       communication will start to work. Some errors or warnings may
       be written in the log-file shortly after the start.

2.05:8 To use extended presets, an Ultra V unit (running firmware 3.06
       or later) or an Ultra VII unit is required.