|
Auxiliary commands
|
The driver supports the following auxiliary commands:
- aux1, switches AUX1
- aux2, switches AUX2
- aux3, switches AUX3
- aux4, switches AUX4
|
|
Video Source Configuration |
| Parameter |
Description |
Range |
| Device ID |
This is the address of the connected device. This value corresponds to the value of the address switches in the connected device |
1-999 |
|
|
Driver Specific Settings
|
There are no driver specific settings for this driver.
|
|
Mechanical limits
|
There are no mechanical limits for this driver.
|
|
Light Control
|
There are no light control settings for this driver.
|
|
Extended Driver Specific Settings
|
| Parameter |
Description |
Range |
| MoveSpeed |
The current maximum pan and tilt speed |
1-100
|
| PanMoveTimePerDegree |
The calibration constant for panning. Higher values give greater movements. Calibrate at the most commonly used speed, by adjusting the value until a 360 degree pan request (i.e. "rpan=360") pans 360 degrees exactly. |
1-3000 |
| TiltMoveTimePerDegree |
The calibration constant for tilting. Higher values give greater movements. Calibrate at the most commonly used speed, by adjusting the value until a 90 degree tilt request (i.e. "rpan=90") tilts 90 degrees exactly. |
1-3000 |
| ZoomTime |
The calibration constant for zooming. Higher values give greater zoom changes. Calibrate by confirming that a maximum zoom request performs a maximum zoom. |
1-30000 |
| FocusTime |
The calibration constant for focus changes (time in ms for maximum focus change). Higher values give greater focus changes. Calibrate by confirming that a maximum focus request (i.e "rfocus=9999") at one extreme (e.g. full focus far) takes you to the other. |
1-30000 |
| IrisTime |
The calibration constant for iris changes (time in ms for maximum iris change). Higher values give greater iris changes. Calibrate by confirming that a maximum iris request (i.e."riris=9999") at one extreme (e.g. full iris close) takes you to the other. |
1-30000 |
| CurrentFieldAngle |
The calibration constant for click-in-picture (center) movements. Higher values give greater movements. Calibrate at minimum zoom (i.e. zoom wide) and at the most commonly used speed, by making sure that clicking on an object brings the object to the center of the image. |
1-1800 |
| PanBarRange |
he range (in degrees) to use with panbar requests. Clicking at the very end of a bar will pan half this value in the corresponding direction. |
1-720 |
| TiltBarRange |
The range (in degrees) to use with tiltbar requests. Clicking at the very end of a bar will tilt half this value in the corresponding direction. |
1-720 |
|