PTZ DRIVER RELEASE NOTES ======================== Release date: 2009-08-19 Release type: Production Firmware version: 2.04 Filename: Pelco-2.04.ptz Previous release: 2.03 --------------------------------------------------------------------- Release 2.04: ============= 2.04:1 Added support for Pelco protocol P. The current protocol is changed by a user advanced parameter. 2.04:2 Added support for sending auxiluar commands. Known problems and limitations in version 2.03 ============================================== Note! Some limitations are also device type dependent and can behave different on different Pelco devices! 2.04:3 The implementation does not support the use of same Device ID on a camera using P protocol and a camera using D protocol. 2.04:4 A video source using protocol P cannot be given a Device ID that is exactly 1 higher than another source using protocol D. 2.04:5 To use this version of the driver, firmware 4.30 or higher is required. 2.04:6 With auto-focus set off, after a pan, tilt or zoom movement, the auto-focus will be activated. 2.04:7 With auto-iris set off and zoom wide, after a pan or tilt movement, the auto-iris will be activated. 2.04:8 With auto-iris set on and the iris manual changed, after a zoom movement, the iris is not changed. With auto-iris set on and zoom tele and the iris manual changed, after a pan or tilt movement, the iris is not changed. Known problems and limitations with Pelco Spectra III. ====================================================== 2.04:9 Pan, tilt and zoom positions may sometimes be displayed in the picture. 2.04:10 To enable auto-iris, a 15 degrees pan or tilt movement is required. ======================================================