PTZ DRIVER RELEASE NOTES ======================== Release date: 2005-11-08 Release type: Production Firmware version: 2.02 Filename: Pelco-2.02.ptz Previous release: 1.01 --------------------------------------------------------------------- Release 2.02: ============= 2.02:1 Added notification for driver movements. This is used by motion detection and it can also be used by events. 2.02:2 Added support for OSD menus and backlight compensation (Pelco model dependent). Known problems and limitations in version 2.02 ============================================== Note! Some limitations are also device type dependent and can behave different on different Pelco devices! 2.02:3 To use this version of the driver, firmware 4.30 or higher is required. 2.02:4 With auto-focus set off, after a pan, tilt or zoom movement, the auto-focus will be activated. 2.02:5 With auto-iris set off and zoom wide, after a pan or tilt movement, the auto-iris will be activated. 2.02:6 With auto-iris set on and the iris manual changed, after a zoom movement, the iris is not changed. With auto-iris set on and zoom tele and the iris manual changed, after a pan or tilt movement, the iris is not changed. Known problems and limitations with Pelco Spectra III. ====================================================== 2.02:7 Pan, tilt and zoom positions may sometimes be displayed in the picture. 2.02:8 To enable auto-iris, a 15 degrees pan or tilt movement is required. ======================================================