PTZ DRIVER RELEASE NOTES
                 ========================

Release date: 2007-11-26

Release type: Production

Driver version: 2.00

Filename: Harristech.ptz

Previous release: None

---------------------------------------------------------------------

Release 2.00
=============

This is the first release of this driver.


Known problems and limitations in version 2.00
==============================================

Note! Some limitations are also model dependent and can behave
      different on different Harristech models.

2.00:1 To use this version of the driver, firmware 4.30 or higher
       is required.

2.00:2 The driver supports only one PTZ-unit and the Device ID can not
       be changed.

2.00:3 The number of presets is PTZ-unit dependent (default = 4).
       Update a parameter in the driver if more presets are supported by the
       PTZ-unit. See the help page in the driver for more information.

2.00:4 The relay 1 and relay 2 have special behaviour and limitations. Only
       one of these relays can be activated at the same time. Also relay 3
       have some limitations when used together with realy 1 and relay 2.
       See the help page in the driver for more information.

2.00:5 Only one continuous (joystick) movement can be performed at the same
       time. If one movement request is performed, all other movements will be
       ignored. The different movements are checked and performed in this
       order: pan/tilt, zoom, focus and iris. See the help page in the driver
       for more information.

2.00:6 The driver and the PTZ-unit don't support combined realtive movements.
       Combined relative movements will be performed one by one after each
       other.

2.00:7 The On-screen display only supports the "Open" and "Close" commands.
       All other commands are ignored. The On-screen display is PTZ-unit 
       dependent and might not be supported on all Harristech/camera units.