PTZ DRIVER RELEASE NOTES ======================== Release date: 2016-11-23 Release type: Production Firmware version: 4.15 Filename: Pelco-4.15-crisv32-3_32-4_0.ptz Previous release: 4.10 --------------------------------------------------------------------- Release 4.15: ============= 4.15:1 Updated navigation in OSD menu to accomodate for more PTZ models. Known problems and limitations in version 4.15 ============================================== Note! Some limitations are also device type dependent and can behave different on different Pelco devices! 4.15:2 The implementation does not support the use of same Device ID on a camera using P protocol and a camera using D protocol. 4.15:3 A video source using protocol P cannot be given a Device ID that is exactly 1 higher than another source using protocol D. 4.15:4 To use this version of the driver, firmware 5.20 or higher is required, or for AXIS Q7401 firmware 5.20.2 or higher is required. 4.15:5 With auto-focus set off, after a pan, tilt or zoom movement, the auto-focus will be activated. 4.15:6 With auto-iris set off and zoom wide, after a pan or tilt movement, the auto-iris will be activated. 4.15:7 With auto-iris set on and the iris manual changed, after a zoom movement, the iris is not changed. With auto-iris set on and zoom tele and the iris manual changed, after a pan or tilt movement, the iris is not changed. Known problems and limitations with Pelco Spectra III. ====================================================== 4.15:8 Pan, tilt and zoom positions may sometimes be displayed in the picture. 4.15:9 To enable auto-iris, a 15 degrees pan or tilt movement is required. ======================================================