PTZ DRIVER RELEASE NOTES
                 ========================

Release date: 2020-10-02

Release type: Production

Firmware version: 4.02

Filename: Ernitec-4.02-armv7-3_62-5_1.ptz

---------------------------------------------------------------------

Release 4.02:
=============

4.02:1 This driver will now also work with Ernitec model Orion/3-DN.


Known problems and limitations
==============================
Note! Some limitations are also device type dependent and can behave
      different on different Ernitec devices!

L01 To use this version of the driver, firmware 5.50 or higher
    is required.

Known problems and limitations with Ernitec "Orion 361 23C"
===========================================================
L02 For the model "Orion 361 23C", the address switches should be set
    to the value of ("Device ID" + 1).

L03 When performing a combined pan and tilt movement, the tilt movement
    will start with a short delay after the pan movement.

L04 The same tilt up and tilt down movement will result in a little bit
    different length of the tilt movement.

L05 The iris and autoiris functions are not supported when the model
    "Orion 361 23C" is selected. It is still possible to manipulate
    the iris and autoiris functions by using the internal OSD menues
    inside the PTZ unit.

===========================================================