PTZ DRIVER RELEASE NOTES
                 ========================

Release date: 2012-06-12

Release type: Production

Firmware version: 4.15

Filename: Pelco-4.15-crisv32-3_28-3_0.ptz

Previous release: 4.10

---------------------------------------------------------------------

Release 4.15:
=============

4.15:1 Updated navigation in OSD menu to accomodate for more PTZ models.

Known problems and limitations in version 4.15
==============================================

Note! Some limitations are also device type dependent and can behave
      different on different Pelco devices!

4.15:2 The implementation does not support the use of same Device ID
       on a camera using P protocol and a camera using D protocol.

4.15:3 A video source using protocol P cannot be given a Device ID 
       that is exactly 1 higher than another source using protocol D.

4.15:4 To use this version of the driver, firmware 5.20 or higher
       is required, or for AXIS Q7401 firmware 5.20.2 or higher is required.

4.15:5 With auto-focus set off, after a pan, tilt or zoom movement,
       the auto-focus will be activated.

4.15:6 With auto-iris set off and zoom wide, after a pan or tilt movement,
       the auto-iris will be activated.

4.15:7 With auto-iris set on and the iris manual changed,
       after a zoom movement, the iris is not changed.
       With auto-iris set on and zoom tele and the iris manual changed,
       after a pan or tilt movement, the iris is not changed.


Known problems and limitations with Pelco Spectra III.
======================================================
4.15:8 Pan, tilt and zoom positions may sometimes be displayed in the picture.

4.15:9 To enable auto-iris, a 15 degrees pan or tilt movement is required.
======================================================