BODY WORN SYSTEM FIRMWARE RELEASE NOTE ================================================================================================================================= Products affected: W100, W800, W700, W701, TW1200 Release date: 2020-07-10 Release type: Production Firmware version: 9.75.1 New product: No previous release Languages: English, German, French, Spanish, Italian Compatibility: AXIS IP Utility 4.14 or above, AXIS Camera Station 5.33 or above, Genetec Security Center 5.9.2.0 or above, Milestone XProtect 2020 R1 + AXIS Optimizer Body Worn Extension 1.0.55 or above, Genetec Clearance --------------------------------------------------------------------------------------------------------------------------------- Release 9.75.1 ======================================================================== This is the first official release for the body worn solution. Known Bugs/Limitations ================================================================================ * When there is no NTP server in place, make sure to set manual time at the "Date and time" page during system setup. Otherwise the "Next" button at the Summary page will be disabled and system setup can not be finished. * Unregistered BWC with older firmware shows up underneath “New” section in Body Worn Manager and then disappears during firmware upgrade until after the firmware is upgraded. If the end user "Add" the BWC before the firmware is upgraded, it needs to be done again after that. * Recordings may not be transferred to the content destination if there is not enough licenses on the content destination. * If a BWC has not finished offloading recording on one system controller, it can't be used on another system controller in the same system until the offloading is finished. * When BWC is undocked immediately after it is removed, the BWC can get stuck in “unregistering in process” state in Body Worn Manager. The problem is gone when docking the BWC again and waiting for it to show underneath “New” section in Body Worn Manager. * If a BWC (or user) is removed from Body Worn Manager when there are recordings left on the BWC (assigned to the user), the recordings may not be transferred to the content destination. * When using HTTPS to connect to Body Worn Manager and leaving the browser open on "Devices", Body Worn Manager will stop responding after a few days, although it is still possible to dock and undock BWCs as normal. The problem is gone after a reboot of the system controller. * When using Security Center as the content destination, if the time difference between system controller and Security Center is bigger than 15 seconds, a default user named by the camera's mac address is created. All recordings created with that BWC will be uploaded to the default user. * Putting BWC back to back against a radio device can cause black screen and a flickering image, which can take a while to recover. The same thing won't happen if they are placed side by side. * No support for Internet Explorer in Body Worn Manager. Limited support for Edge and Firefox.